Base Pair Geometries

Discussion of all aspects of biological molecules, biochemical processes and laboratory procedures in the field.

Moderators: honeev, Leonid, amiradm, BioTeam

Post Reply
Posts: 1
Joined: Tue Dec 01, 2009 1:03 am

Base Pair Geometries

Post by klm46 » Tue Dec 01, 2009 1:06 am

Hey, confused on this point:

Are base pair properties such as roll and tilt defined to be relative to the adjacent base pair, or relative to the helical axis? eg. Is tilt the angle a base pair makes with a line perpindicular to the helical axis, or is it the angle it makes with the adjacent base?

I have been scanning over as many relevant papers as I can find, but am more confused than when I started - there does not seem to be much of a consensus.


Posts: 345
Joined: Thu Jun 25, 2009 3:15 am

Post by kolean » Tue Dec 01, 2009 2:19 pm

Relative to the helical axis.

Is this about the different DNAs?
to go with: ... _Z-DNA.png

User avatar
Posts: 257
Joined: Sat Mar 05, 2005 6:56 pm
Location: Serbia

Re: Base Pair Geometries

Post by zami'87. » Sat Dec 05, 2009 3:10 am

Check Understanding DNA by Calladine and Drew.They explain geometry of DNA and connect it with sequence..propeller twisted AA/TT with little roll and slide values(around 0 if you look plot) , GG/CC repel when slide is near zero(forbidden zone) they're moved(bistable on plot), CA/TG with wide range of slide and roll values. I haven't read the whole book so far but I must admit that it's very interesting :wink:
Every man is a star whose light can make shadows dance differently and change our view of landscape permanently***

Post Reply

Who is online

Users browsing this forum: No registered users and 13 guests